Selleys Knead It Multipurpose

1. Clean surface free of grease, dirt and dust. For best results roughen bond area prior to cleaning.
2. Cut off required amount. Replace disc on remaining portion. Use gloves to avoid messing hands. To mix, knead with fingers to a uniform colour.  If mixing is difficult, warm to room temperature.
3. Apply to surface to be repaired (within 2 minutes of mixing) and mould to shape if required.
4. For a smooth appearance, remove excess and hand rub with water or a damp cloth before hardening begins.
5. Trim away any excess before initial hardening.  Remove any residues with acetone prior to initial hardening. Hardened excess may be sanded or trimmed away once fully cured.
6. After 5-10 minutes Knead It Multi Purpose will harden and begin to form a strong bond. After 60 minutes Knead It Multi Purpose may be drilled, sanded, machined, filed, sawed or painted.
7. Wash hands thoroughly with soap and water before product hardens.

        Limitations:

• Not recommended for filling or sealing joints/cracks subject to movement as the cured product is extremely hard and inflexible
• *Does not adhere to polyethylene, polypropylene or Polytetrafluoroethylene (Teflon) or silicone rubber 

• Ensure the putty and hardener are mixed properly. Knead It will become warm as it is mixed. A good indication its mixed properly is when you have a uniform colour, and feel a mild heat radiating from the Knead It.
• To help determine when your knead it has set, keep a small piece off to check when it is hard, it indicates your job is done.
• Set time increases at temperatures below 20°C.
• Use Knead It Aqua for applications in wet/ submerged areas.
• Use Knead It Steel for applications on metal or fuel contact.

• Remove excess and hand rub with water or a damp cloth
  before hardening begins.