Selleys Fix & Go Multi Grip

1. Ensure surfaces to be bonded are clean, dry, free of dust and close fitting.
2. Remove cap assembly carefully and pierce membrane with sharp object.
3. Coat both surfaces evenly with glue. Bring surfaces together and press firmly for a few minutes until adhesive grabs. Sufficient bond strength for practical use is achieved after 10-12 hours. Allow longer for large areas or if non-porous materials (e.g. PVC) are being bonded.
4. Wipe nozzle with cloth, replace cap and store in a cool, dry place.

Limitations:

• Not suitable for bonds exposed to temperatures above 90°C.
• * *Not for Teflon, polypropylene, polyethylene plastics or polystyrene foam. May cause some vinyl & plastics to discolour or harden. If in doubt please test on a small hidden area first.
  
  

• For a faster bond, apply adhesive and leave surfaces open for 1 minute before pressing together. For very porous surfaces, seal by first coating the surface with a thin layer of adhesive and allow it to dry before applying a second coat to form the bond as directed.
• Use acetone (nail polish remover) to clean up spills and excess adhesive before it sets.

• Use acetone (nail polish remover) to clean up spills and excess adhesive before it sets.