Ready to use

Selleys Spakfilla ColourSmart


Selleys Spakfilla Coloursmart is a ready-mixed, lightweight and quick setting filler. It is pink when applied drying to off white when ready to sand.


  • Fills cracks and holes in a single application
  • Pre-mixed so easy to use
  • Filler is pink when applied and dries to off white when ready to sand
  • Minimal shrinkage so no need to overfill
  • Very fast drying allowing sanding and painting in a short time period
  • Comes complete with a filling spatula for ease of use
  • Is water based, so can be cleaned up with water
  • Paintable with oil and water based paints

Available Sizes

  • 180g Tub

Available at

  • Bunnings
  • Home Hardware
  • Mitre 10
  • Thrifty Link

Where can this product be used?

  • Filling cracks and holes on surfaces where no structural movement occurs
  • Filling cracks in walls, ceilings, doors, windows
  • Repairing holes in walls, ceilings, doors and windows
  • Recommended for use in interiors only
  • Nailing this product is not recommended
  • Not recommended for use on plastic or metal surfaces
  • Product is not flexible so not suitable for use bewteen surfaces that are subject the structural movement
  • Not recommended for use where load or compression occurs as product may be crushed e.g. behind a door if the knob touches against the wall.

What materials is this product suitable for?

  • Plaster
  • Wallboard
  • Wood
  • Plasterboard

How to use this product

  • Ensure surfaces are clean, dry and free of loose material.
  • Using the flexible spatula provided on the lid, press the filler firmly into crack/hole and smooth off surface; there is no need to overfill.
  • Sand and paint with water-based paints after the product turns off-white (2 hours for holes up to 2mm deep). If more than 2mm deep, or in cold/humid conditions, expect longer drying times.
  • For oil-based paints allow 24 hours before painting.

Handy tips

  • Painting with oil-based paints is not recommended until 24 hours after filler has been applied
  • Water based paints may be used immediately after filler has set
  • If filler is found to have stiffened prior to use*, stir product. If still too dry add one teaspoon of water and stir again. *Material that has actually hardened should be discarded.
  • Application tools may be cleaned with water
  • Sand back to a smooth finish using a Rota Cota Foam Sanding Block as the foam sponge will follow the contours of the surface
  • Before painting, clean dust and filler particles using Selleys Sugar Soap or Selleys Super Kleen.

Safety tips

  • If in eyes, hold eyes open and rinse in water. Seek medical attention if irritation persists
  • For further detail on the safe use of this product, please refer to the Material Safety Data Sheet, which can be downloaded from this site.
  • Clean tools in water before Spakfilla Coloursmart sets.