Quick and Easy Adhesives

Selleys Power Grip™


Power Grip™ sticks and withstands virtually anything*. Powered by SIL-X® technology for high versatility and durability, this glue will work even in the most extreme conditions*. Where normal glues fail, Power Grip™ rises to the challenge.


  • Sticks and withstands virtually anything*
  • Outperforms Super glue on uneven, porous or non rigid surfaces.
  • Shockproof – bends on impact
  • High flexibility
  • High bond strength
  • Gap filling: Sticks uneven surfaces together, which means you can fix things that didn’t break cleanly.
  • Water & Weather proof
  • Temperature Resistant -15°C – 120°C
  • Dishwasher Safe
  • Works on uneven surfaces
  • Set time 3 minutes

Available Sizes

  • 4g
  • 5g
  • 8g
  • 10g
  • 20g


  • Dries opaque

Available At

  • Bunnings
  • Woolworths
  • Big W
  • Mitre 10
  • Home Timber & Hardware

Contact the store to confirm stock availability, as some stores may have a limited range.

*Not suitable for polyethylene, polypropylene or PTFE. Not for permanent water immersion. Avoid UV exposure

What materials is this product suitable for?

  • Metal
  • Wood
  • Stone
  • Bricks
  • Concrete
  • Masonry
  • Ceramic
  • Glass
  • Foam
  • Leather
  • Laminate
  • Vinyl
  • Fabric
  • Cardboard
  • Most plastics (will not bond polyethylene or polypropylene plastics; for these use Selleys Plastics Glue)

How to use this product

  • Use in a well-ventilated area
  • Ensure surfaces are clean and dry. Remove cap and apply to a surface.
  • Simply apply and hold the bond in place for at least 1 minute or until set (around 3 mins, allow longer for non-porus surfaces such as metal and plastics).
  • If necessary clamp or tape to support until adhesive sets – for porous surfaces such as wood and ceramics, practical strength is usually achieved within 12 hours.
  • Product cures rapidly, wipe nozzle clean and tightly replace cap immediately. Store upright in a cool dry place.
  • Clean up before adhesive sets with turps or acetone.

Handy tips

  • Initial bond in 3 minutes, full cure in 12-24 hours.
  • To reduce set times on non-porus surfaces, keep surfaces apart for 30 seconds before bringing together.

Safety Tips

  • Causes skin irritation. May cause an allergic skin reaction.
  • Causes serious eye damage.
  • Avoid skin and eye contact and breathing vapours. Use in a well-ventilated area.
  • Wash thoroughly after handling.
  • Product releases methanol during cure.

Storage and re-use

  • Wipe nozzle clean, replace cap & store in a cool dry place.

*Not suitable for polyethylene, polypropylene or PTFE. Not for permanent water immersion. Avoid UV exposure